This chapter describes switch‐related logging and network management commands and how to
use them.
For information about...
Configuring System Logging
Monitoring Network Events and Status
Managing Switch Network Addresses and Routes
Configuring Simple Network Time Protocol (SNTP)
Configuring Node Aliases
Configuring System Logging
Purpose
To display and configure system logging, including Syslog server settings, Syslog default settings,
and the logging buffer.
Commands
For information about...
show logging server
set logging server
clear logging server
show logging default
set logging default
clear logging default
show logging application
set logging application
Logging and Network Management
Note: The commands in this chapter pertain to network management of the SecureStack C2
device from the switch CLI only. For information on router-related network management tasks,
including reviewing router ARP tables and IP traffic, refer to
14
Chapter
19.
Refer to page...
14-1
14-12
14-17
14-27
14-35
Refer to page...
14-2
14-3
14-4
14-4
14-5
14-6
14-6
14-7
SecureStack C2 Configuration Guide 14-1