Chapter 15: Rmon Configuration; Rmon Monitoring Group Functions; Rmon Monitoring Group Functions And Commands - Enterasys SecureStack C2 C2G170-24 Configuration Manual

This chapter describes the commands used to configure RMON on a SecureStack C2 switch.
For information about...

RMON Monitoring Group Functions

Design Considerations
Statistics Group Commands
History Group Commands
Alarm Group Commands
Event Group Commands
Filter Group Commands
Packet Capture Commands
RMON
Monitoring Group Functions
RMON (Remote Network Monitoring) provides comprehensive network fault diagnosis,
planning, and performance tuning information and allows for interoperability between SNMP
management stations and monitoring agents. RMON extends the SNMP MIB capability by
defining additional MIBs that generate a much richer set of data about network usage.
"groups" each gather specific sets of data to meet common network monitoring requirements.
Table 15‐1 lists the RMON monitoring groups supported on SecureStack C2 devices, each group's
function and the elements it monitors, and the associated configuration commands needed.
Table 15-1 RMON Monitoring Group Functions and Commands
RMON
Group
Statistics
What It Does...
Records statistics
measured by the RMON
probe for each monitored
interface on the device.
RMON Configuration
What It Monitors...
Packets dropped, packets
sent, bytes sent (octets),
broadcast and multicast
packets, CRC errors,
oversized and undersized
packets, fragments, jabbers,
and counters for packets.
SecureStack C2 Configuration Guide 15-1
15
Refer to page...
15-1
15-2
15-3
15-6
15-9
15-13
15-17
15-22
These MIB
CLI Command(s)
"show rmon stats" on
page 15-4
"set rmon stats" on
page 15-4
"clear rmon stats" on
page 15-5