Set Webview; Show Ssl - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Example
This example shows how to display WebView status:
C2(rw)->show webview
WebView is Enabled.

set webview

Use this command to enable or disable WebView on the switch.
Syntax
set webview {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Usage
It is good practice for security reasons to disable HTTP access on the switch when finished
configuring with WebView, and then to only enable WebView on the switch when changes need to
be made.
Example
This example shows how to disable WebView on the switch:
C2(rw)->set webview disable

show ssl

Use this command to display SSL status.
Syntax
show ssl
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Enable or disable WebView on the switch.
SecureStack C2 Configuration Guide 3-51
set webview