Set Nodealias; Show Nodealias Config Output Details - Enterasys SecureStack C2 C2G170-24 Configuration Manual

set nodealias

-----------
ge.2.1
ge.2.2
ge.2.3
ge.2.4
ge.2.5
ge.2.6
ge.2.7
ge.2.8
ge.2.9
Table 14‐8 provides an explanation of the command output.
Table 14-8 show nodealias config Output Details
Output Field
Port Number
Max Entries
Used Entries
Status
set nodealias
Use this command to enable or disable a node alias agent on one or more ports, or set the
maximum number of alias entries stored per port.
Syntax
set nodealias {enable | disable | maxentries maxentries} port-string
Parameters
enable | disable
maxentries maxentries
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Usage
Upon packet reception, node aliases are dynamically assigned to ports enabled with an alias
agent, which is the default setting on SecureStack C2 devices. Node aliases cannot be statically
created, but can be deleted using the command "clear nodealias config" (page 14‐37).
14-36 Logging and Network Management
-----------
16
47
47
47
47
47
47
47
4000
What It Displays...
Port designation.
Maximum number of alias entries configured for this port.
Number of alias entries (out of the maximum amount configured) already used by
this port.
Whether or not a node alias agent is enabled (default) or disabled on this port.
Enables or disables a node alias agent.
Set the maximum number of alias entries stored per port. Valid range
is 0 to 4096. The default value is 32.
Specifies the port(s) on which to enable/disable node alias agent or set
a maximum number of stored entries.
------------
0
0
2
0
0
2
0
0
1
------
Enable
Enable
Enable
Enable
Enable
Enable
Enable
Enable
Enable