Set Spantree Mstcfgid; Clear Spantree Mstcfgid - Enterasys SecureStack C2 C2G170-24 Configuration Manual

set spantree mstcfgid

MAC address) have not been changed. For information on using the set spantree mstcfgid
command to change these settings, refer to "set spantree mstcfgid" on page 9‐16:
C2(su)->show spantree mstcfgid
MST Configuration Identifier:
Format Selector: 0
Configuration Name: 00:01:f4:89:51:94
Revision Level: 0
Configuration Digest: ac:36:17:7f:50:28:3c:d4:b8:38:21:d8:ab:26:de:62
set spantree mstcfgid
Use this command to set the MST configuration name and/or revision level.
Syntax
set spantree mstcfgid {cfgname name | rev level}
Parameters
cfgname name
rev level
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the MST configuration name to "mstconfig":
C2(su)->set spantree mstconfigid cfgname mstconfig

clear spantree mstcfgid

Use this command to reset the MST revision level to a default value of 0, and the configuration
name to a default string representing the bridge MAC address.
Syntax
clear spantree mstcfgid
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
9-16 Spanning Tree Configuration
Specifies an MST configuration name.
Specifies an MST revision level. Valid values are 0 ‐ 65535.