Show Port Lacp - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Example
This example shows how to reset the single port LAG function back to disabled:
C2(su)->clear lacp singleportlag

show port lacp

Use this command to display link aggregation information for one or more underlying physical
ports.
Syntax
show port lacp port port-string {[status {detail | summary}] | [counters]}
Parameters
port port‐string
status detail |
summary
counters
Defaults
None.
Mode
Switch command, read‐only.
Usage
State definitions, such as ActorAdminState and Partner AdminState, are indicated with letter
abbreviations. If the show port lacp command displays one or more of the following letters, it
means the state is true for the associated actor or partner ports:
• E = Expired
• F = Defaulted
• D = Distributing (tx enabled)
• C = Collecting (rx enabled)
• S = Synchronized (actor and partner agree)
• G = Aggregation allowed
• S/l = Short/Long LACP timeout
• A/p = Active/Passive LACP
For more information about these states, refer to set port lacp (page
specification.
Examples
This example shows how to display detailed LACP status information
C2(su)-> show port lacp port
Displays LACP information for specific port(s). For a detailed description
of possible port‐string values, refer to "Port String Syntax Used in the CLI"
on page 7‐2.
Displays LACP status in detailed or summary information.
Displays LACP counter information.
ge.
1.12 status detail
show port lacp
7‐48) and the IEEE 802.3 2002
f
or port ge.1.12:
SecureStack C2 Configuration Guide 7-47