Timers Spf - Enterasys SecureStack C2 C2G170-24 Configuration Manual

timers spf

Parameters
number
Defaults
None.
Mode
Interface configuration: C2
Usage
The priority value is communicated between routers by means of hello messages and influences
the election of a designated router.
Example
This example shows how to set the OSPF priority to 20 for the VLAN 1 interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip ospf priority 20
timers spf
Use this command to change OSPF timer values to fine‐tune the OSPF network. The no form of
this command restores the default timer values (5 seconds for delay and 10 seconds for holdtime).
Syntax
timers spf spf-delay spf-hold
no timers spf
Parameters
spf‐delay
spf‐hold
Defaults
None.
Mode
Router configuration: C2(su)‐>router(Config‐router)#
Example
This example shows how to set SPF delay time to 7 seconds and hold time to 3:
C2(su)->router(Config)#router ospf 1
C2(su)->router(Config-router)#timers spf 7 3
20-16 IPv4 Routing Protocol Configuration
Specifies the router's OSPF priority in a range from 0 to 255. Default value is
1.
(su)‐>router(Config‐if(Vlan 1))#
Specifies the delay, in seconds, between the receipt of an update and the SPF
execution. Valid values are 0 to 4294967295.
Specifies the minimum amount of time, in seconds, between two
consecutive OSPF calculations. Valid values are 0 to 4294967295. A value of
0 means that two consecutive OSPF calculations are performed one
immediately after the other.