Set Linkflap Globalstate; Set Linkflap Portstate - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Table 7-4 show linkflap metrics Output Details (Continued)
Output Field
TimeElapsed
Violations

set linkflap globalstate

Use this command to globally enable or disable the link flap detection function.
Syntax
set linkflap globalstate {disable | enable}
Parameters
disable | enable
Defaults
By default, the function is disabled globally and on all ports.
Mode
Switch mode, read‐write.
Usage
By default, the function is disabled globally and on all ports. If disabled globally after per‐port
settings have been configured using the linkflap commands, per‐port settings will be retained.
Example
This example shows how to globally enable the link trap detection function.
C2(rw)->set linkflap globalstate enable

set linkflap portstate

Use this command to enable or disable link flap monitoring on one or more ports.
Syntax
set linkflap portstate {disable | enable} [port-string]
Parameters
disable | enable
port‐string
Defaults
If port‐string is not specified, all ports are enabled or disabled.
What it displays...
Time (in seconds) since the last link down event.
Number of link flap violations on listed ports since system start.
Globally disables or enables the link flap detection function.
Disables or enables the link flap detection function.
(Optional) Specifies the port or ports on which to disable or enable
monitoring.
set linkflap globalstate
SecureStack C2 Configuration Guide 7-25