Show Logging Server; Show Logging Server Output Details - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show logging server

For information about...
clear logging application
show logging local
set logging local
clear logging local
show logging buffer
show logging server
Use this command to display the Syslog configuration for a particular server.
Syntax
show logging server [index]
Parameters
index
Defaults
If index is not specified, all Syslog server information will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display Syslog server configuration information:
C2(ro)->show logging server
IP Address
-------------------------------------------------------------------------
1 132.140.82.111 local4 warning(5)
2 132.140.90.84
Table 14‐1 provides an explanation of the command output.
Table 14-1 show logging server Output Details
Output Field
IP Address
Facility
Severity
Description
Port
Status
14-2 Logging and Network Management
(Optional) Displays Syslog information pertaining to a specific server
table entry. Valid values are 1‐8.
Facility Severity
local4 warning(5)
What It Displays...
Syslog server's IP address. For details on setting this using the set logging server
command, refer to "set logging
Syslog facility that will be encoded in messages sent to this server. Valid values are:
local0 to local7.
Severity level at which the server is logging messages.
Text string description of this facility/server.
UDP port the client uses to send to the server.
Whether or not this Syslog configuration is currently enabled or disabled.
Description
default 514 enabled
default 514 enabled
server" on page 14-3.
Refer to page...
14-8
14-9
14-9
14-10
14-10
Port Status