Show Ip Protocol; Set Ip Protocol - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show ip protocol

Mode
Switch command, read‐write.
Example
This example shows how to clear the system IP address:
C2(rw)->clear ip address
show ip protocol
Use this command to display the method used to acquire a network IP address for switch
management.
Syntax
show ip protocol
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the method used to acquire a network IP address:
C2(su)->show ip protocol
System IP address acquisition method: dhcp

set ip protocol

Use this command to specify the protocol used to acquire a network IP address for switch
management.
Syntax
set ip protocol {bootp | dhcp | none}
Parameters
bootp
dhcp
none
Defaults
None.
3-12 Basic Configuration
Selects BOOTP as the protocol to use to acquire the system IP address.
Selects DHCP as the protocol to use to acquire the system IP address.
No protocol will be used to acquire the system IP address.