Clear Multiauth Session-Timeout - Enterasys SecureStack C2 C2G170-24 Configuration Manual

clear multiauth session-timeout

clear multiauth session-timeout
Use this command to reset the maximum number of consecutive seconds an authenticated session
may last before termination of the session to its default value of 0.
Syntax
clear multiauth session-timeout [dot1x | mac | pwa]
Parameters
dot1x
mac
pwa
Defaults
If no authentication method is specified, the session timeout value is reset to its default value of 0
for all authentication methods.
Mode
Switch mode, read‐write.
Example
This example resets the session timeout value for the IEEE 802.1X authentication method to 0
seconds.
C2(su)->clear multiauth session-timeout dot1x
23-44 Authentication and Authorization Configuration
(Optional) Specifies the IEEE 802.1X port‐based network access control
authentication method for which to reset the timeout value to its
default.
(Optional) Specifies the Enterasys MAC authentication method for
which to reset the timeout value to its default.
(Optional) Specifies the Enterasys Port Web Authentication method for
which to reset the timeout value to its default.