Configuring Port Traffic Rate Limiting; Purpose; Commands; Show Port Ratelimit - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Configuring Port Traffic Rate Limiting

Configuring Port Traffic Rate Limiting

Purpose

To limit the rate of inbound traffic on the SecureStack C2 device on a per port/priority basis. The
allowable range for the rate limiting is 64 kilobytes per second minimum up to the maximum
transmission rate allowable on the interface type.
Rate limit is configured for a given port and list of priorities. The list of priorities can include one,
some, or all of the eight 802.1p priority levels. Once configured, the rate of all traffic entering the
port with the priorities configured to that port is not allowed to exceed the programmed limit. If
the rate exceeds the programmed limit, frames are dropped until the rate falls below the limit.

Commands

The commands to configure traffic rate limiting are listed below.
For information about...

show port ratelimit

set port ratelimit
clear port ratelimit
show port ratelimit
Use this command to show the traffic rate limiting configuration on one or more ports.
Syntax
show port ratelimit [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, rate limiting information will be displayed for all ports.
Mode
Switch command, read‐only.
12-10 Port Priority and Rate Limiting Configuration
(Optional) Displays rate limiting information for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 7‐2.
Refer to page...
12-10
12-12
12-13