Set Tftp Timeout; Clear Tftp Timeout - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Example
This example shows the output of this command.
C2(ro)->show tftp settings
TFTP packet timeout (seconds): 2
TFTP max retry: 5

set tftp timeout

Use this command to configure how long TFTP will wait for a reply of either an acknowledgement
packet or a data packet during a data transfer.
Syntax
set tftp timeout seconds
Parameters
seconds
Defaults
None.
Mode
Switch command, read‐write.
Example
This example sets the timeout period to 4 seconds.
C2(rw)->set tftp timeout 4

clear tftp timeout

Use this command to reset the TFTP timeout value to the default value of 2 seconds.
Syntax
clear tftp timeout
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Specifies the number of seconds to wait for a reply. The valid range is
from 1 to 30 seconds. Default value is 2 seconds.
set tftp timeout
SecureStack C2 Configuration Guide 3-45