Table of Contents
Advertisement
Parameters
time
Defaults
None.
Mode
Switch command, read‐write.
Usage
The IGMP group membership interval time sets the frequency of host‐query frame transmissions
and must be greater than the IGMP maximum response time as described in "set igmpsnooping
maxresponse" on page 13‐5.
Example
This example shows how to set the IGMP group membership interval to 250 seconds:
C2(su)->set igmpsnooping groupmembershipinterval 250
set igmpsnooping maxresponse
Use this command to configure the IGMP query maximum response time for the system.
Syntax
set igmpsnooping maxresponse time
Parameters
time
Defaults
None.
Mode
Switch command, read‐write.
Usage
This value must be less than the IGMP maximum response time described in "set igmpsnooping
groupmembershipinterval" on page 13‐4.
Specifies the IGMP group membership interval. Valid values are 2 ‐ 3600
seconds.
This value works together with the set igmpsnooping maxresponsetime
command to remove ports from an IGMP group and must be greater than
the max response time value.
Specifies the IGMP maximum query response time. Valid values are 100 ‐
255 seconds. The default value is 100 seconds.
This value works together with the set igmpsnooping
groupmembershipinterval command to remove ports from an IGMP group
and must be lesser than the group membership interval value.
set igmpsnooping maxresponse
SecureStack C2 Configuration Guide 13-5
Advertisement
Table of Contents
