Show Port Mirroring; Set Port Mirroring - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show port mirroring

Use this command to display the source and target ports for mirroring, and whether mirroring is
currently enabled or disabled for those ports.
Syntax
show port mirroring
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display port mirroring information. In this case, ge.1.4 is configured
as a source port and ge.1.11 is a target and mirroring has been enabled between these ports:
C2(su)->show port mirroring
Port Mirroring
==============
Source Port =
Target Port =
Frames Mirrored = Rx and Tx
Port Mirroring status enabled.

set port mirroring

Use this command to create a new mirroring relationship or to enable or disable an existing
mirroring relationship between two ports.
Syntax
set port mirroring {create | disable | enable} source destination}
ge.
1.4
ge.
1.11
Notes: When a port mirror is created, the mirror destination port is removed from VLAN 1's egress
list after a reboot.
"MAC addresses will be learned for packets tagged with the mirror VLAN ID. This will prevent the
ability to snoop traffic across multiple hops.
show port mirroring
SecureStack C2 Configuration Guide 7-35