Clear Snmp View; Configuring Snmp Target Parameters; Purpose; Commands - Enterasys SecureStack C2 C2G170-24 Configuration Manual

clear snmp view

clear snmp view
Use this command to delete an SNMPv3 MIB view.
Syntax
clear snmp view viewname subtree
Parameters
viewname
subtree
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to delete SNMP MIB view "public":
C2(su)->clear snmp view public 1.3.6.1

Configuring SNMP Target Parameters

Purpose

To review and configure SNMP target parameters. This controls where and under what
circumstances SNMP notifications will be sent. A target parameter entry can be bound to a target
IP address allowed to receive SNMP notification messages with the set snmp targetaddr
command ("set snmp targetaddr" on page 8‐26).

Commands

For information about...

show snmp targetparams

set snmp targetparams
clear snmp targetparams
show snmp targetparams
Use this command to display SNMP parameters used to generate a message to a target.
Syntax
show snmp targetparams [targetParams] [volatile | nonvolatile | read-only]
8-22 SNMP Configuration
Specifies the MIB view name to be deleted.
Specifies the subtree name of the MIB view to be deleted.
Refer to page...
8-22
8-24
8-24