Clear System Temperature - Enterasys SecureStack C2 C2G170-24 Configuration Manual

clear system temperature

Usage
On the platforms that support this feature, temperature sensors are located in several different
locations within the device. Threshold calibrations have been calculated separately for each
platform. The thermal overtemp threshold is the high‐water mark that, when reached, triggers an
alert to warn the system administrator that the device is operating at high temperatures.
The values set with this command can be viewed with the show system command.
Refer to the Release Note for your platform to determine if this feature is supported on your
platform.
Example
The following example enables sending SNMP traps and sets the overtemp threshold to 60%.
C2(su)->set system temperature trap enable overtemp-threshold 60
clear system temperature
Use this command to reset system high temperature parameters to their default values, on the
platforms that support this feature.
Syntax
clear system temperature
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Usage
This command resets all the high temperature parameters to their default values:
• Syslog alerts are disabled by default.
• Trap alerts are disabled by default.
• Overtemp threshold is 100% by default.
Example
This example resets all high temperature parameters to their defaults.
C2(su)->clear system temperature
3-18 Basic Configuration