show lldp port trap
Tx-Enabled Ports
Rx-Enabled Ports
show lldp port trap
Use this command to display the ports that are enabled to send an LLDP notification when a
remote system change has been detected or an LLDP‐MED notification when a change in the
topology has been sensed. Ports are enabled to send LLDP notifications with the set lldp port trap
command and to send LLDP‐MED notifications with the set lldp port med‐trap command.
Syntax
show lldp port trap [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, LLDP port trap information will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display LLDP port trap information for all ports.
C2(ro)->show lldp port trap
Trap-Enabled Ports
MED Trap-Enabled Ports:
show lldp port tx-tlv
Use this command to display information about which optional TLVs have been configured to be
transmitted on ports. Ports are configured to send optional TLVs with the set lldp port tx‐tlv
command.
Syntax
show lldp port tx‐tlv [port‐string]
Parameters
port‐string
Defaults
If port‐string is not specified, TLV configuration information will be displayed for all ports.
6-16 Discovery Protocol Configuration
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12
(Optional) Displays the port or range of ports that have been enabled
to send LLDP and/or LLDP‐MED notifications.
:
(Optional) Displays information about TLV configuration for one or a
range of ports.