Ip Pimsm; Ip Pimsm Staticrp - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Stackable switches
Hide thumbs Also See for SecureStack C2 C2G170-24:
Table of Contents

Advertisement

ip pimsm

For information about...
show ip pimsm interface
show ip pimsm neighbor
show ip pimsm rp
show ip pimsm rphash
show ip pimsm staticrp
show ip mroute
ip pimsm
This command sets administrative mode of PIM‐SM multicast routing across the router to 
enabled. IGMP must be enabled before PIM‐SM can be enabled. By default, both IGMP and PIM 
are globally disabled. The no form of this command disables PIM (across the entire stack, if 
applicable).
Syntax
ip pimsm
no ip pimsm
Parameters
None.
Defaults
None.
Mode
Global router configuration: C2(su)‐>router(Config)#
Example
This example shows how to globally enable and disable PIM:
C2(su)->router(Config)# ip pimsm
C2(su)->router(Config)# no ip pimsm

ip pimsm staticrp

This command is used to create a manual Rendezvous Point IP address for the PIM‐SM router. 
The no form of this command removes a previously configured RP.
Syntax
ip pimsm staticrp ipaddress groupadress groupmask
no ip pimsm staticrp ipaddress groupadress groupmask
20-50 IPv4 Routing Protocol Configuration
Refer to page...
20-54
20-55
20-56
20-57
20-58
20-59

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SecureStack C2 C2G170-24 and is the answer not in the manual?

This manual is also suitable for:

C2h124-24Securestack c2

Table of Contents