Dynamic ARP Inspection Commands
Dynamic ARP Inspection Commands
For information about...
set arpinspection vlan
set arpinspection trust
set arpinspection validate
set arpinspection limit
set arpinspection filter
show arpinspection access-list
show arpinspection ports
show arpinspection vlan
show arpinspection statistics
clear arpinspection validate
clear arpinspection vlan
clear arpinspection filter
clear arpinspection limit
clear arpinspection statistics
set arpinspection vlan
Use this command to enable dynamic ARP inspection on one or more VLANs, and optionally,
enable logging of invalid ARP packets.
Syntax
set arpinspection vlan vlan-range [logging]
Parameters
vlan‐range
logging
Defaults
Logging is disabled by default.
Mode
Switch command, read‐write.
Usage
This command enables dynamic ARP inspection (DAI) on one or more VLANs. When DAI is
enabled on a VLAN, DAI is effectively enabled on the interfaces (physical ports or LAGs) that are
members of that VLAN.
17-20 DHCP Snooping and Dynamic ARP Inspection
Specifies the VLAN or range of VLANs on which to enable dynamic
ARP inspection.
(Optional) Enables logging of invalid ARP packets for that VLAN.
Refer to page...
17-20
17-21
17-22
17-22
17-23
17-24
17-25
17-25
17-26
17-27
17-27
17-29
17-30
17-30