set policy maptable response
multiauth port command (page 23‐37) to set the number of RFC 3580 users (numusers) allowed
per Gigabit port. Up to six users can be configured per Gigabit port.
Syntax
show policy maptable response
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the current policy maptable response setting:
C2(rw)->show policy maptable response
policy
set policy maptable response
Sets the maptable response from the default of policy to tunnel to allow up to six VLAN
authorized users to be configured per Gigabit port.
Syntax
set policy maptable response {policy | tunnel}
Parameters
policy
tunnel
Defaults
Set to policy.
Mode
Switch command, read‐write.
Usage
This command puts the switch in either "policy mode" (the default) or "tunnel mode," which is
RFC3580 VLAN mapping.
23-46 Authentication and Authorization Configuration
Sets the maptable response to policy. This is the default setting, which
allows authentication of up to six multiauth users per port.
Sets the maptable response to tunnel, which allows authentication of up
to six multiauth users per port. This setting is required to configure
VLAN authorization for multiple users per Gigabit port.