Configuring Access Lists; Purpose; Commands; Show Access-Lists - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Configuring Access Lists

Purpose

To review and configure security access control lists (ACLs), which permit or deny access to
routing interfaces based on protocol and IP address restrictions.

Commands

For information about...

show access-lists

access-list (standard)
access-list (extended)
ip access-group
show access-lists
Use this command to display configured IP access lists when operating in router mode.
Syntax
show access‐lists [number]
Parameters
access‐list‐
number
Defaults
If number is not specified, the entire table of access lists will be displayed.
Mode
Any router mode.
Example
This example shows how to display IP access list number 101. This is an extended access list,
which permits or denies ICMP, UDP and IP frames based on restrictions configured with the one
of the access‐list commands. For details on configuring standard access lists, refer to "access‐list
Router: These commands can be executed when the device is in router mode only. For details
on how to enable router configuration modes, refer to
page 18-2.
Note: Access Control Lists are limited to 100 per stack and 9 per interface on C2 stack
configurations, or mixed configurations of C2 and C3 switches in a stack. On C3-only
configurations, up to 100 Access Control Lists with up to 20 access rules per list and 60 per
interface are supported per stack .
(Optional) Displays access list information for a specific access list number.
Valid values are between 1 and 199.
Configuring Access Lists
"Enabling Router Configuration
Refer to page...
23-75
23-76
23-77
23-79
SecureStack C2 Configuration Guide 23-75
Modes" on