Show Newaddrtrap - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Commands
For information about...

show newaddrtrap

set newaddrtrap
show snmp notify
set snmp notify
clear snmp notify
show snmp notifyfilter
set snmp notifyfilter
clear snmp notifyfilter
show snmp notifyprofile
set snmp notifyprofile
clear snmp notifyprofile
show newaddrtrap
Use this command to display the global and port‐specific status of the SNMP new MAC addresses
trap function.
Syntax
show newaddrtrap [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, the status of the new MAC addresses trap function will be displayed
for all ports.
Mode
Switch command, read‐only.
Usage
By default, this function is disabled globally and per port.
Example
This example displays the status for Gigabit Ethernet ports 1 through 5 in slot 1.
C2(ro)->show newaddrtrap ge.1.1-5
New Address Traps Globally disabled
Port
--------- ------------
(Optional) Displays the status of the new MAC addresses trap function
on specific ports.
Enable State
show newaddrtrap
Refer to page...
8-29
8-30
8-30
8-31
8-32
8-33
8-34
8-34
8-35
8-36
8-36
SecureStack C2 Configuration Guide 8-29