Set Dhcp Pool Netbios-Name-Server; Clear Dhcp Pool Netbios-Name-Server - Enterasys SecureStack C2 C2G170-24 Configuration Manual

set dhcp pool netbios-name-server

Mode
Switch command, read‐write.
Example
This example removes the domain name from the address pool "auto1."
C2(rw)->clear dhcp pool auto1 domain-name
set dhcp pool netbios-name-server
Use this command to assign one or more NetBIOS name servers for the DHCP clients served by
the address pool being configured. Up to 8 NetBIOS name servers can be configured.
Syntax
set dhcp pool poolname netbios-name-server address [address2 ... address8]
Parameters
poolname
address
address2 ... address8
Defaults
None.
Mode
Switch command, read‐write.
Example
This example assigns a NetBIOS name server at 10.15.10.1 to the address pool being configured.
C2(rw)->set dhcp pool auto1 netbios-name-server 10.15.10.1

clear dhcp pool netbios-name-server

Use this command to remove the NetBIOS namer server list from the address pool being
configured.
clear dhcp pool poolname netbios-name-server
Parameters
poolname
Defaults
None.
16-26 DHCP Server Configuration
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the IP address of a NetBIOS name server.
(Optional) Specifies, in order of preference, up to 7 additional NetBIOS
name server addresses.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.