Clear Config - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Examples
This example shows how to reset the system:
C2(su)->reset
Are you sure you want to reload the stack? (y/n) y
Saving Configuration to stacking members
Reloading all switches.
This example shows how to reset unit 1:
C2(su)->reset 1
Are you sure you want to reload the switch? (y/n) y
Reloading switch 1.
This switch is manager of the stack.
STACK: detach 3 units

clear config

Use this command to clear the user‐defined configuration parameters.
Syntax
clear config [all]
Parameters
all
Defaults
If all is not specified, stacking configuration parameters will not be cleared.
Mode
Switch command, read‐write.
Usage
When using the clear config command to clear configuration parameters in a stack, it is important
to remember the following:
• Use clear config to clear configuration parameters without clearing stack unit IDs. This
command WILL NOT clear stack parameters and avoids the process of re‐numbering the
stack.
• Use clear config all when it is necessary to clear all configuration parameters, including stack
unit IDs (if applicable) and switch priority values.
• Use the clear ip address command to clear the IP address.
Configuration parameters and stacking information can also be cleared on the master unit only by
selecting option 10 (restore configuration to factory defaults) from the boot menu on switch
startup. This selection will leave stacking priorities on all other units, if applicable.
(Optional) Clears user‐defined configuration parameters (and stack unit
numbers and priorities, if applicable).
SecureStack C2 Configuration Guide 3-49
clear config