Configuring Inband Management (Ge Upstream) - Huawei SmartAX MA5616 Configuration Manual

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Figure 3-15 Flowchart for configuring inband management in the GPON upstream mode
Use Telnet to log in to the ONU through
Result
After logging in to the MA5616 through the OLT or maintenance terminal, you can configure
the MA5616. For instructions on CLI, see CLI Operation Characteristics.

3.1.4 Configuring Inband Management (GE Upstream)

This topic describes how to use Telnet to log in to the MA5616 through an upstream port (inband
management port) of the MA5616 for inband management.
Issue 04 (2011-10-30)
Start
Set up the configuration environment
Configure the L3 interface of the OLT
Configure corresponding profiles
Adding an ONU
Configure the IP address of the ONU
and the corresponding information
Is it a WAN environment?
Yes
Add a route
the OLT or maintenance terminal
End
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
No
3 Basic Configuration
24