Huawei SmartAX MA5616 Configuration Manual page 232

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Parameter
4
6
Issue 04 (2011-10-30)
Description
Indicates whether a wildcard is
used for the registration of the
MG interface.
To configure whether a
wildcard is used for the
registration of an MG interface,
use this parameter.
This parameter can be
configured only when the MG
interface is in the local closed
state.
When a wildcard is used for
registration, all the terminals
connecting to the MG interface
register with the MGC through
a message. This reduces the
quantity of messages between
the MG interface and the MGC.
When the wildcard is not used
for registration, all the terminals
on the MG interface need to
register with the MGC in order.
The registration without a
wildcard is also called "single-
endpoint registration".
Indicates whether the MG
interface supports device
authentication.
To configure an MG interface
to or not to support
authentication, use this
parameter.
After the device authentication
is supported, run the auth
(h248) command to configure
the authentication parameters,
and then run the reset(h248)
command to reset the MG
interface. In this way, the MGC
can manage the security of the
MGs and avoid illegal
registration with the MGC.
CAUTION
Resetting the MG interface may
interrupt the services.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Default Setting
Numeral type. Range: 0-1.
l 0: Indicates that a wildcard is
used.
l 1: Indicates that a wildcard is
not used.
Default: 0
Numeral type. Range: 0-1.
l 0: Indicates that device
authentication is supported.
l 1: Indicates that device
authentication is not
supported.
Default: 1
221