Huawei SmartAX MA5616 Configuration Manual page 356

SmartAX MA5616 Multi-service Access Module
Configuration Guide
huawei(config-mvlan4003)#igmp mode proxy
Are you sure to change IGMP mode?(y/n)[n]:y
Step 4 Configure the multicast uplink port.
huawei(config-mvlan4003)#igmp uplink-port 0/0/1
huawei(config-mvlan4003)#multicast-vlan 4002
huawei(config-mvlan4002)#igmp uplink-port 0/0/1
Step 5 Configure multicast programs.
l In static configuration mode, you can run the igmp program add command to add multicast programs. You
l If the IGMP version of the multicast VLAN is V3, the source IP address of the program in the multicast
huawei(config-mvlan4002)#igmp program add name program1 ip 224.1.1.1 sourceip
10.10.10.10
huawei(config-mvlan4002)#multicast-vlan 4003
huawei(config-mvlan4003)#igmp program add name program2 ip 224.1.1.2 sourceip
10.10.10.11
Step 6 Configure multicast users.
huawei(config-mvlan4003)#btv
huawei(config-btv)#igmp user add service-port 100
huawei(config-btv)#igmp user add service-port 101
huawei(config-btv)#multicast-vlan 4002
huawei(config-mvlan4002)#igmp multicast-vlan member service-port 100
huawei(config-mvlan4002)#multicast-vlan 4003
huawei(config-mvlan4003)#igmp multicast-vlan member service-port 101
huawei(config-mvlan4003)#quit
Step 7 Save the data.
huawei(config)#save
----End
Result
l
l
Configuration File
The following part describes the configuration file of this configuration example. Note that
certain steps need to be performed manually and the configuration file cannot be imported
directly.
Create VLANs and add an uplink port to the VLANs. This step needs to be performed manually.
vlan 4002 to 4003 smart
port vlan 4002 to 4003 0/0 1
Create service ports.
service-port 100 vlan 4002 vdsl mode ptm 0/1/0 multi-service user-vlan untagged rx-
cttr 6 tx-cttr 6
service-port 101 vlan 4003 vdsl mode ptm 0/1/1 multi-service user-vlan untagged rx-
cttr 6 tx-cttr 6
Configure multicast VLANs and the IGMP mode. This step needs to be performed manually.
Issue 04 (2011-10-30)
NOTE
cannot name a program, instead the system automatically names a program PROGRAM-M, in which M is
the index of the added program.
VLAN must be configured. If the IGMP version of the multicast VLAN is V2, the source IP address of the
program in the multicast VLAN cannot be configured.
User 1 belongs to multicast VLAN 4002 and user 1 can watch the program with IP address
224.1.1.1 provided by ISP1.
User 2 belongs to multicast VLAN 4003 and user 2 can watch the program with IP address
224.1.1.2 provided by ISP2.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Configuration Example of Services on the MA5616
Through GPON Upstream Transmission
345