Huawei SmartAX MA5616 Configuration Manual page 360

SmartAX MA5616 Multi-service Access Module
Configuration Guide
huawei(config-mvlan4003)#igmp mode proxy
Are you sure to change IGMP mode?(y/n)[n]:y
Step 4 Configure the multicast uplink port.
huawei(config-mvlan4003)#igmp uplink-port 0/0/1
huawei(config-mvlan4003)#multicast-vlan 4002
huawei(config-mvlan4002)#igmp uplink-port 0/0/1
Step 5 Configure multicast programs.
Configure the program in the multicast VLAN in dynamic generation mode, and specify the IP
address range of the program that can be requested by the user to 224.1.1.1-224.1.1.2.
The execution of the igmp match mode command for configuring the mode of the multicast program will cause
the user to go offline. Therefore, plan the multicast program mode before configuring the multicast program.
This command can be executed only when the IGMP function is disabled.
huawei(config-mvlan4002)#igmp match group ip 224.1.1.1 to-ip 224.1.1.2
huawei(config-mvlan4002)#multicast-vlan 4003
huawei(config-mvlan4003)#igmp match group ip 224.1.1.1 to-ip 224.1.1.2
Step 6 Configure multicast users.
huawei(config-mvlan4002)#btv
huawei(config-btv)#igmp user add service-port 100
huawei(config-btv)#igmp user add service-port 101
huawei(config-btv)#multicast-vlan 4002
huawei(config-mvlan4002)#igmp multicast-vlan member service-port 100
huawei(config-mvlan4002)#multicast-vlan 4003
huawei(config-mvlan4003)#igmp multicast-vlan member service-port 101
huawei(config-mvlan4003)#quit
Step 7 Save the data.
huawei(config)#save
----End
Result
l
l
Configuration File
The following part describes the configuration file of this configuration example. Note that
certain steps need to be performed manually and the configuration file cannot be imported
directly.
Create VLANs and add an uplink port to the VLANs. This step needs to be performed manually.
vlan 4002 to 4005 smart
port vlan 4002 to 4005 0/0 1
Create service ports.
service-port 100 vlan 4004 vdsl mode ptm 0/1/0 multi-service user-vlan untagged rx-
cttr 6 tx-cttr 6
service-port 101 vlan 4005 vdsl mode ptm 0/1/1 multi-service user-vlan untagged rx-
cttr 6 tx-cttr 6
Configure multicast VLANs and the IGMP mode. This step needs to be performed manually.
Issue 04 (2011-10-30)
NOTE
User 1 belongs to multicast VLAN 4002 and user 1 can watch the program with IP address
224.1.1.1 provided by ISP1.
User 2 belongs to multicast VLAN 4003 and user 2 can watch the program with IP address
224.1.1.2 provided by ISP2.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Configuration Example of Services on the MA5616
Through GPON Upstream Transmission
349