Huawei SmartAX MA5616 Configuration Manual page 331

SmartAX MA5616 Multi-service Access Module
Configuration Guide
4.
5.
Step 6 Configure the user account security.
The PITP P mode can be enabled to protect the user account against theft and roaming. The
RAIO mode can be customized according to actual requirements. Here, the cntel is considered
as an example.
huawei(config)#pitp enable pmode
huawei(config)#raio-mode cntel pitp-pmode
For details about the PITP configuration for the user account security, see
Roaming of User Account Through
Step 7 Save the data.
huawei(config)#save
----End
Verification
l
l
l
l
Configuration File
Configuration File in the ADSL access mode:
Issue 04 (2011-10-30)
NOTE
l If a matched traffic profile is not available in the system, run the traffic table ip command to configure
a new traffic profile.
l On the MA5616, the user access rate can be limited by either a traffic profile or a VDSL line profile.
When both profiles are configured, the smaller one of the two rates configured in the profiles is adopted
as the user bandwidth. In this example, the traffic profile is used to limit the user access rate.
Run the service-port command to create a service port, adopt traffic profile 5, and set the
S-VLAN ID to 50. Set the VDSL channel mode to PTM, and create service port 3 on VDSL
port 0/1/0. To facilitate the maintenance of the service port, also configure the service port
description.
huawei(config)#service-port 3 vlan 50 vdsl mode ptm 0/1/0 inbound traffic-
table
index 5 outbound traffic-table index 5
huawei(config)#service-port desc 3 description Vlanid:50/vdsl/vpi:1vci:39/
stacking
Set the C-VLAN ID of the preset service port 3 to 10 for identifying the user. Configure
the important user packet with a higher priority so that the user packet can be processed
with precedence, and set the priority of the inner VLAN to 4.
huawei(config)#stacking label service-port 3 10
huawei(config)#stacking inner-priority service-port 3 4
NOTE
Step 1: Configure the user name and password for the dialup on the modem (the user name
and password must be the same as those configured on the BRAS).
Step 2: Dial up on the PC by using the PPPoE dialup software. After the dialup is successful,
the user can access the Internet.
Step 3: When FTP is used to download files, after the dialup is performed on the PPPoE
dialup software, the PPPoE dialup software prompts that the dialup is successful. Then, the
PC can access the Internet in the PPPoE mode.
Step 4: When downloading files through FTP, you can open Task Manager in Windows
and click Networking to check the link speed. Then, you can calculate the Internet access
rate by the following formula: Attainable Internet access rate = Computer network adapter
rate/48 x 53 x 8. The calculation result approximates to the planned 2048 kbit/s.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Configuration Example of Services on the MA5616
PITP.
Through GPON Upstream Transmission
3.10.1 Configuring Anti-Theft and
320