Huawei SmartAX MA5616 Configuration Manual page 55

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Table 3-5 Configuration principles of uplink and cascaded ports on an MA5616
Control Board
CCUB
Default configuration
Table 3-6
Table 3-6 Default settings of the attributes of an Ethernet port
Parameter
Auto-negotiation
mode of the port
Port rate
Duplex mode
Network cable
adaptation mode
Flow control
Procedure
l
Issue 04 (2011-10-30)
Daughter Board
on the Control
Board
GP1A
EP1A
GE1A
lists the default settings of the attributes of an Ethernet port.
Default Setting (Optical Port)
Disabled
GE optical port: 1000 Mbit/s
Full-duplex
Not supported
Disabled
Configure the physical attributes of an Ethernet port.
1. (Optional) Set the auto-negotiation mode of the Ethernet port.
Run the auto-neg command to set the auto-negotiation mode of the Ethernet port. You
can enable or disable the auto-negotiation mode:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Configuration Principles
l GE port 0: is set as a cascaded or uplink port.
l GPON port: is always set as an uplink port.
l GE port 0: is set as a cascaded or uplink port.
l EPON port: is always set as an uplink port.
l GE port 0: is set as a cascaded or uplink port.
l GE port 1: is always set as an uplink port.
Default Setting (Electrical
Port)
Enabled
NA
NOTE
After the auto-negotiation mode
of the port is disabled, you can
configure the port rate.
NA
NOTE
After the auto-negotiation mode
of the port is disabled, you can
configure the duplex mode.
l FE electrical port: auto
l GE electrical port: normal
Disabled
3 Basic Configuration
44