Huawei SmartAX MA5616 Configuration Manual page 220

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Table 7-1 Data plan for configuring the VoIP PSTN service based on the H.248 protocol
Item
MG interface
data
(The data
configuration
must be
consistent with
the data
configuration
on the MGC.)
Issue 04 (2011-10-30)
Parameter Media and
s of the signaling
media upstream VLAN
stream and
Media and
signaling
signaling
stream
upstream port
Media IP address
and signaling IP
address
Default IP address
of the MG
Attribute MG interface ID
parameter
s of the
MG
interface
Signaling port ID
NOTE
of the MG
Parameter
interface
s listed
here are
mandator
y, which
means
that the
MG
IP address of the
interface
primary MGC to
fails to be
started if
which the MG
these
interface belongs
parameter
s are not
Port ID of the
configure
primary MGC to
d.
which the MG
interface belongs
Coding mode of
the MG interface
Transmission
mode of the MG
interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Remarks
It is used as the upstream VLAN of the
VoIP service to be configured. Standard
VLAN is recommended.
It is used as the upstream port of the
VoIP service to be configured.
These IP addresses must be selected
from the media and signaling IP address
pools. The media and signaling IP
address pools consist of all the IP
addresses of the L3 interface of the
media and signaling upstream VLAN.
It is the IP address of the next hop from
the MA5616 to the MGC.
It is the MG interface ID used for the
VoIP service to be configured. The
MA5616 supports only one virtual
access gateway (VAG).
It is the transport layer protocol port ID
used for the signaling exchange
between the MA5616 (AG) and the
MGC.
Default signaling port ID specified in
the H.248 protocol: 2944 (text) and
2945 (binary)
When dual homing is not configured,
the parameters of the primary MGC
need to be configured. When dual
homing is configured, the IP address
and the port ID of the secondary MGC
also need to be configured.
Currently, only the text coding mode is
supported.
The transmission mode is selected
according to the requirements on the
MGC side. Generally, UDP is adopted.
209