Huawei SmartAX MA5616 Configuration Manual page 426

Multi-service access module
Table of Contents

Advertisement

SmartAX MA5616 Multi-service Access Module
Configuration Guide
3.
4.
Issue 04 (2011-10-30)
NOTE
By default, an ADSL port is in the activated state. Before binding a template to the port, you must deactivate
the port.
huawei(config)#interface shl 0/4
huawei(config-if-shl-0/4)#deactivate 0
huawei(config-if-shl-0/4)#activate 0 3
huawei(config-if-shl-0/4)#alarm-config 0 1
huawei(config-if-shl-0/4)#quit
Run the display traffic table ip command to query the traffic profiles that exist in the
system.
huawei(config)#display traffic table ip from-index
0
{ <cr>|to-
index<K> }:
Command:
display traffic table ip from-index
0
----------------------------------------------------------------------------
TID CIR(kbps) CBS(bytes) PIR(kbps) PBS(bytes) Pri Copy-policy
Policy
----------------------------------------------------------------------------
0
1024
pri
1
2496
pri
2
512
pri
3
576
pri
4
64
pri
5
2048
pri
6
off
pri
----------------------------------------------------------------------------
Total Num : 7
According to service requirement, the user access rate is 2048 kbit/s. The query result shows
that traffic profile 5 meets the requirement.
NOTE
l If no traffic profile in the system meets the service requirement, run the traffic table ip command to
configure a new traffic profile.
l On the MA5616, the user access rate can be limited by either a traffic profile or an SHDSL line profile.
When both profiles are configured, the user bandwidth adopts the minimum value in the two profiles.
In this example, the traffic profile is used to limit the user access rate.
Run the service-port command to create a service port. The index of the new service virtual
port is 2, the access port is port 0/4/0, traffic profile 5 meets the service requirement, and
the S-VLAN is VLAN 50. The VPI and VCI must be the same as the management VPI and
VCI of the peer modem. Assume that the management VPI and VCI of the modem are 1
and 39. To facilitate the maintenance of the service port, also configure the service port
description.
huawei(config)#service-port 2 vlan 50 shdsl mode atm 0/4/0 vpi 1 vci 39 inbound
traffic-table index 5 outbound
traffic-table index 5
huawei(config)#service-port desc 2 description MA5616HW/Vlanid:50/shdsl/smart
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Configuration Example of Services on the MA5616
34768
2048
81872
4992
163744
18384
1024
20432
1152
4048
128
67536
4096
135072
off
off
Through GE Upstream Transmission
69536
6 -
6 -
36768
0 -
40864
2 -
8096
4 -
0 -
off
0 -
Pri-
tag-
tag-
tag-
tag-
tag-
tag-
tag-
415

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save PDF