Huawei SmartAX MA5616 Configuration Manual page 547

SmartAX MA5616 Multi-service Access Module
Configuration Guide
l
Issue 04 (2011-10-30)
NOTE
If no multicast subtending port is configured and multicast users are directly configured, the
maximum number of multicast users that each multicast user can demand is limited. If multicast
users are directly configured:
l To set authentication of a multicast user, run the igmp profile add command to create a right
profile, run the igmp profile command to modify right parameters in the profile, and then run
the igmp user bind-profile command to bind the right profile to the multicast user.
l To authenticate a multicast user, remove parameter no-auth when adding the multicast user.
The corresponding procedure is as follows:
huawei(config-btv)#igmp user add service-port 1000 no-auth
huawei(config-btv)#igmp user add service-port 1001 no-auth
huawei(config-btv)#multicast-vlan 1000
huawei(config-mvlan1000)#igmp multicast-vlan member service-port 1000
huawei(config-mvlan1000)#igmp multicast-vlan member service-port 1001
11. Set the IGMP version.
Use IGMP V3.
huawei(config)#multicast-vlan 1000
huawei(config-mvlan10000)#igmp version v3
12. Select the IGMP mode.
Select the IGMP proxy mode.
huawei(config-mvlan10000)#igmp mode proxy
Are you sure to change IGMP mode?(y/n)[n]:y
13. Configure the IGMP upstream port.
The IGMP upstream port is port 0/19/0 and works in the default mode, and protocol
packets are transmitted to all the IGMP upstream ports in the multicast VLAN.
huawei(config-mvlan10000)#igmp uplink-port 0/19/0
14. Set the multicast global parameters.
In this example, the default settings are used for all the multicast global parameters.
15. Configure the program library.
The multicast IP address of the program is 224.1.1.10 and the IP address of the program
source is 10.10.10.10
huawei(config-mvlan10000)#igmp program add name program1 ip 224.1.1.10
sourceip 10.10.10.10
16. Configure a log server.
Enable CDR log reporting, and configure the IP address of the active server to
10.10.10.20.
huawei(config-mvlan10000)#btv
huawei(config-btv)#igmp cdr enable
huawei(config-btv)#quit
huawei(config)#file-server auto-backup cdr primary 10.10.10.20 tftp
17. Save the data.
huawei(config)#save
Configure the ONU.
1. Log in to the ONU to perform the configuration.
On the OLT, use the management IP address of the ONU to log in to the ONU through
Telnet. User name: root (default). Password: mduadmin (default).
2. Configure the traffic profile.
You can run the display traffic table ip command to query the traffic profiles existing
in the system. If the traffic profiles existing in the system do not meet the requirements,
you need to run the traffic table ip command to add a traffic profile.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Configuration Examples of the FTTx
536