Huawei SmartAX MA5616 Configuration Manual page 525

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Issue 04 (2011-10-30)
Configure the mapping between the GEM port and the ONU-side service to the
VLAN mapping mode (default), map the service port of management (the
CVLAN ID is 8) to GEM port 0, and map the service port of VoIP service (the
CVLAN ID is 200) to GEM port 1.
huawei(config-gpon-lineprofile-10)#mapping-mode vlan
huawei(config-gpon-lineprofile-10)#gem mapping 0 0 vlan 8
huawei(config-gpon-lineprofile-10)#gem mapping 1 1 vlan 200
After the configuration is complete, run the commit command to make the
configured parameters take effect.
huawei(config-gpon-lineprofile-10)#commit
huawei(config-gpon-lineprofile-10)#quit
c. (Optional) Configure an alarm profile.
– The ID of the default GPON alarm profile is 1. The thresholds of all the alarm
parameters in the default alarm profile are 0, which indicates that no alarm is
generated.
– In this example, the default alarm profile is used, and therefore the
configuration of the alarm profile is not required.
– Run the gpon alarm-profile add command to configure an alarm profile,
which is used for monitoring the performance of an activated ONU line.
4. Add an ONU on the OLT.
a. Add an ONU.
ONU 1 and ONU 2 are connected to GPON port 0/2/1 through an optical splitter.
The IDs of ONU 1 and ONU 2 are 1 and 2 respectively. The SN of ONU 1 is
32303131B39FD641 and that of ONU 2 is 32303131B39FD642. The
management mode is SNMP and the line profile 10 is bound.
There are two ways to add an ONU. Select either of the two ways according to
actual conditions.
– Add an ONU offline: If the password or SN of an ONU is obtained, you can
run the ont add command to add the ONU offline.
– Automatically find an ONU: If the password or SN of an ONU is unknown,
run the port ont-auto-find command in the GPON mode to enable the ONU
auto-find function of the GPON port. Then, run the ont confirm command
to confirm the ONU.
To add an ONU offline, do as follows:
huawei(config)#interface gpon 0/2
huawei(config-if-gpon-0/2)#ont add 1 ontid 1 sn-auth
32303131B39FD641
snmp ont-lineprofile-id 10
huawei(config-if-gpon-0/2)#ont add 1 ontid 2 sn-auth
32303131B39FD642
snmp ont-lineprofile-id 10
To automatically find an ONU, do as follows:
huawei(config)#interface gpon 0/2
huawei(config-if-gpon-0/2)#port 1 ont-auto-find enable
huawei(config-if-gpon-0/2)#display ont autofind 1
---------------------------------------------------------------------
---
Number
F/S/P
Ont SN
Password
Loid
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Configuration Examples of the FTTx
: 1
: 0/2/1
: 32303131B39FD641
:
: 0000000000
514