Huawei SmartAX MA5616 Configuration Manual page 42

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Figure 3-22 Flowchart for configuring the NMS
configuring the MXU
Set the SNMP parameters
Set the IP address of the
Set the source address for
Procedure
l
Issue 04 (2011-10-30)
Flowchart for
Start
Enable trap sending
target host for traps
traps sending
Save the data
End
Configuration procedure on the device
1. Configure the SNMP parameters.
a. Configure the community names and the access rights.
Run the snmp-agent community command to configure the community names
and the access rights.
NOTE
The read community name is public. The write community name is private.
The read community name and the write community name on the device must be the
same as those configured on the U2000.
huawei(config)#snmp-agent community read public
huawei(config)#snmp-agent community write private
b. (Optional) Set the information about the administrator.
Run the snmp-agent sys-info command to set the contact of the SNMP Agent
administrator and the physical position of the device.
Contact of the administrator: HW-075528780808. Physical position of the
device: Shenzhen_China.
huawei(config)#snmp-agent sys-info contact HW-075528780808
huawei(config)#snmp-agent sys-info location Shenzhen_China
c. Set the SNMP version.
Run the snmp-agent sys-info command to set the required SNMP version.
huawei(config)#snmp-agent sys-info version v1
NOTE
The SNMP version on the device must be the same as that configured on the U2000.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Basic Configuration
31