Table of Contents
Advertisement
SmartAX MA5616 Multi-service Access Module
Configuration Guide
Issue 04 (2011-10-30)
Run the route add 10.50.1.0 mask 255.255.255.0 10.10.1.1 command to add a
route.
Run the route print command to query the information about the current routing
table.
NOTE
If the IP address of the outband NMS port and the IP address of the U2000 are in the same
network segment, you need not configure the route.
2.
Log in to the U2000.
3.
Configure the SNMP parameters.
NOTE
A default SNMP profile exists in the system and is considered in this example. If you need to
configure a new profile, do as follows:
a.
Choose Administration > NE Communicate > Default Access Protocol
Parameters from the main menu.
b.
In Default Access Protocol Parameters, click the SNMPv2 Parameters tab,
and then click Add.
c.
Set the profile name, and then set other parameters according to the plan.
d.
Click OK. Then, the SNMP parameters are configured.
4.
Add a device.
a.
Right-click in the main topology, and then choose New > NE from the shortcut
menu.
b.
In the dialog box that is displayed, set relevant parameters.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Basic Configuration
37
Hide quick links:
Advertisement
Table of Contents
