Huawei SmartAX MA5616 Configuration Manual page 512

SmartAX MA5616 Multi-service Access Module
Configuration Guide
----End
Result
Users can enjoy the high-speed Internet service with PC by PPPoE.
After configuration is complete, use PCs to perform PPPoE. If the system displays "Error 678",
troubleshoot the fault as follows:
1.
2.
Configuration File
On the OLT side.
vlan 100 smart
vlan attrib 100 satcking
port vlan 100 0/19 0
dba-profile add profile-name PPPOE type4 max 102400
ont-lineprofile gpon profile-id 10
tcont 4 dba-profile-name PPPOE
gem add 0 eth tcont 4
gem add 1 eth tcont 4
mapping-mode vlan
gem mapping 0 0 vlan 8
gem mapping 1 1 vlan 1001
commit
quit
Issue 04 (2011-10-30)
NOTE
In the case of batch service provisioning, run the multi-service-port command to add service ports
in batches.
10. Save the data.
huawei(config)#save
Perform PPPoE dialup on a PC. On the ONU, run the display mac-address all command
to check whether there is a MAC address of the PC. If there is a MAC address of the PC,
the PC is connected properly to the ONU. Proceed to 2. If there is not such a MAC address,
check whether the ONU is configured properly as follows:
a. In the corresponding xDSL mode, run the display port state command to check the
related port status.
l If the port is in the activating state, wait until the port is activated and then create
a service port.
l If the port is in the deactivated state, run the activate command to activate the
xDSL port and then create a service port.
b. Check the SVLAN of the service port created by running the service-port command
and check whether the port connected to the PC is properly configured. Ensure that
user-vlan is set to untagged.
On the OLT, run the display mac-address all command to check whether there is a MAC
address of the ONU connected to the PC. If there is such a MAC address, capture packets
and mirror packets on the upper-layer switch to locate faults. If there is not such a MAC
address, check whether the OLT is configured properly.
l Check whether ONUs connected to the OLT have conflict MAC addresses. If there are
conflict MAC addresses, change the conflict MAC addresses.
l Check the SVLAN of the service port created by running the service-port command
and check whether the port connected to the PC is properly configured. Ensure that
user-vlan is consistent with ONU's upstream VLAN configuration.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Configuration Examples of the FTTx
501