Huawei SmartAX MA5616 Configuration Manual page 234

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Parameter
13
15
Issue 04 (2011-10-30)
Description
Indicates the maximum
digitmap matching flag of the
MG interface.
To configure digitmap
matching scheme of the MG
interface, use this parameter.
In the shortest matching, the
collected phone number is
reported immediately after it
matches the digitmap. This is
the quickest report mode. In
certain cases, however, the
phone number is reported
before it is collected
completely. In the longest
matching, even if the collected
phone number matches a
dialing scheme, the phone
number is not reported because
more numbers may be received.
If there is no dialing within the
duration of the short timer
(default: 5s), the phone number
is reported after the short timer
times out. Otherwise, the
system matches other digitmap
schemes.
You can run the digitmap-
timer command to configure
the time length of the digitmap
timer.
Indicates whether the function
of filtering media streams by
source port is enabled on an MG
interface.
To enable or disable the
function of filtering media
streams by source port on an
MG interface, use this
parameter.
When the function of filtering
media streams by source port is
enabled on the MG interface,
only the media streams from the
specific ports can be received.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Default Setting
Numeral type. Range: 0-1.
l 0: Indicates that the match
follows the protocol.
l 1: Indicates the longest
match.
l 2: Indicates the shortest
match.
Default: 2
Numeral type. Range: 0-1.
l 0: Indicates that media
streams are not filtered by
source port.
l 1: Indicates that media
streams are filtered by source
port.
Default: 0
223