Huawei SmartAX MA5616 Configuration Manual page 309

SmartAX MA5616 Multi-service Access Module
Configuration Guide
l
Default Configuration
Table 7-28
Table 7-28 Default configuration of the flows of the FoIP service
Item
FAX transfers mode
FAX flow
Packet-interval-10ms
Negomode
Rfc2198-start-mode
TransEvent
Vbd-codec
Vbd-payload-type
Procedure
Step 1 Configure public fax and modem parameters.
1.
2.
3.
4.
5.
6.
Step 2 Configure the fax working mode.
l
l
1.
2.
Issue 04 (2011-10-30)
RFC 2198 function: Through the redundant transmission, the RFC 2198 function improves
the reliability of data transmission. When the network packet loss occurs, the RFC 2198
can ensure the service quality.
lists the default configuration of the flows of the FoIP service:
Run the fax-modem parameters negomode command to configure the negotiation mode.
(Optional) Run the fax-modem parameters packet-interval-10ms command to enable or
disable the 10ms packing function.
(Optional) Run the fax-modem parameters rfc2198-start-mode command to configure
the RFC2198 function.
(Optional) Run the fax-modem parameters transevent command to configure the
transmission mode of the modem event.
(Optional) Run the fax-modem parameters vbd-codec command to configure the codec
mode of the voice-band data (VBD).
(Optional) Run the fax-modem parameters vbd-pt-type command to configure the
payload type of the VBD.
If the auto-negotiation mode is configured in
If the self-switch mode is configured in
command to configure fax working mode.
Run the fax parameters flow command to configure the fax flow.
(Optional) Run the fax parameters is-port+2 command to configure the T.38 port ID.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Default
Thoroughly
V3 Flow
Disable
Negotiation
Disable Rfc2198SmartStartup
ControlledByMGC
G.711A
Static
Step 1.1, go to Step
Step 1.1, run the fax parameters workmode
2.1.
298