Huawei SmartAX MA5616 Configuration Manual page 421

SmartAX MA5616 Multi-service Access Module
Configuration Guide
4.
5.
Step 6 Configure the security of user accounts.
Assume that the RAIO mode is the user-defined mode, the CID is the access node name frame/
slot/port:vlanid, the RID is the label of the service port where the user is connected. To enable
the DHCP option 82 function with these parameters, do as follows:
huawei(config)#dhcp option82 enable
huawei(config)#raio-mode user-defined dhcp-option82
huawei(config)#raio-format dhcp-option82 cid anid frame/slot/port:vlanid
huawei(config)#raio-format dhcp-option82 rid splabel
l For the details about the security of DHCP accounts, see
Step 7 Save the data.
huawei(config)#save
----End
Verification
l
l
Issue 04 (2011-10-30)
----------------------------------------------------------------------------
Total Num : 7
According to service requirements, the user access rate is 2048 kbit/s. The query result
shows that traffic profile 5 (for inbound and outbound rate limitation) meets the
requirements.
NOTE
l If a matched traffic profile is not available in the system, run the traffic table ip command to configure
a new traffic profile.
l On the MA5616, the user access rate can be limited by either a traffic profile or a VDSL line profile.
When both profiles are configured, the smaller one of the two rates configured in the profiles is adopted
as the user bandwidth. In this example, the traffic profile is used to limit the user access rate.
Run the service-port command to create a service port, adopt traffic profile 5, and set the
S-VLAN ID to 50. Set the VDSL channel mode to PTM, and create service port 3 on VDSL
port 0/1/0. To facilitate the maintenance of the service port, also configure the service port
description.
huawei(config)#service-port 3 vlan 50 vdsl mode ptm 0/1/0 inbound traffic-
table
index 5 outbound traffic-table index 5
huawei(config)#service-port desc 3 description Vlanid:50/vdsl/vpi:1vci:39/
stacking
Set the C-VLAN ID of the preset service port 3 to 10 for identifying the user. Configure
the important user packet with a higher priority so that the user packet can be processed
with precedence, and set the priority of the inner VLAN to 4.
huawei(config)#stacking label service-port 3 10
huawei(config)#stacking inner-priority service-port 3 4
NOTE
User Accounts Through DHCP.
Step 1: After the PC NIC automatically obtains an IP address and a connection to the
Internet is set up, the user can access the Internet.
Step 2: To download a file through FTP, open Windows Task Manager and then click
Networking to observe the link rate. Calculate the Internet access rate by the formula:
attainable Internet access rate = computer NIC rate/48 x 53 x 8. The calculated result
approximates to the planned 2048 kbit/s.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Configuration Example of Services on the MA5616
Through GE Upstream Transmission
3.10.2 Configuring Anti-Theft and Roaming of
410