Huawei SmartAX MA5616 Configuration Manual page 180

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Table 5-6 Default settings of a service port
Parameter
Traffic profile ID
Administration status
Maximum number of learnable MAC
addresses
Procedure
Step 1 Add a traffic profile.
Run the traffic table ip command to add a traffic profile. There are seven default traffic profiles
in the system with the IDs of 0-6.
Before creating a service port, run the display traffic table command to check whether the
traffic profiles in the system meet the requirement. If no traffic profile in the system meets the
requirement, add a traffic profile that meets the requirement. For details about the traffic profile,
see
Step 2 Create a service port.
You can choose to create a single service port or multiple service ports in batches according to
requirements.
l
Issue 04 (2011-10-30)
3.14.1.1 Configuring Traffic Management Based on Service
Run the service-port command to create a single service port. Service ports are classified
into single-service service ports and multi-service service ports. Multi-service service ports
are generally applied to the triple play service scenario.
– Single-service service ports:
Select single-service or do not input multi-service to create a single-service service
port.
– Multi-service service port based on the user-side VLAN:
Select multi-service user-vlan { untagged | user-vlanid | priority-tagged | other-
all }.
– untagged: When untagged is selected, user-side packets do not carry a tag.
– user-vlanid: When user-vlanid is selected, user-side packets carry a tag and the value
of user-vlanid must be the same as the tag carried in user-side packets. The user-
side VLAN is the C-VLAN.
– priority-tagged: When priority-tagged is selected, the VLAN tag is 0 and the
priorities of user-side packets are 0-7.
– other-all: When other-all is selected, service ports for the transparent LAN service
(TLS) are created, which are mainly used in the QinQ transparent transmission
service for enterprises. All the traffic except known traffic in the system is carried
by this channel.
– By user-side service encapsulation mode
Select multi-service user-encap user-encap.
– By VLAN + user-side packet priority (802.1p)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Configuring the xDSL Internet Access Service
Default Setting
0-6
Activated
255
Port.
169