Huawei SmartAX MA5616 Configuration Manual page 277

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Item
Issue 04 (2011-10-30)
Digitmap of the MG interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Remarks
Coding mode Currently, only the text mode is
of the MG supported.
interface
Transmission The transmission mode is
mode of the selected according to the
MG interface requirements of the MGC.
Generally, UDP is used.
Domain name It corresponds to the
of the MG domainName parameter of the
interface MG interface.
When the H.248 protocol is used,
this parameter must be
configured if the MIDType
parameter of the H.248 message
is configured to domainName.
Otherwise, the MG interface
cannot be started. In other
situations, this parameter is
optional.
Device name It is supported by only the H.248
of the MG protocol, and it corresponds to the
interface deviceName parameter of the
MG interface that uses the H.248
protocol.
This parameter must be
configured if the MIDType
parameter of the H.248 message
is configured to domainName.
Otherwise, the MG interface
cannot be started. In other
situations, this parameter is
optional.
The digitmaps are used for certain
special applications such as
emergency calls and emergency
standalone. The digitmaps for
common phone services are
issued to the AG by the MGC, and
therefore such digitmaps need not
be configured on the AG. If the
services such as emergency calls
and emergency standalone are
not required, this parameter need
not be configured.
266