Huawei SmartAX MA5616 Configuration Manual page 448

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Item
Voice service
data
(The data
configuration
must be
consistent with
the data
configuration
on the MGC.)
Issue 04 (2011-10-30)
Software Parameters of an
MG Interface
Ringing Mode of an MG
Interface
TID Format of an MG
Interface
Slot that houses the voice
service board
User Data Phone number
TID
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Configuration Example of Services on the MA5616
Through GE Upstream Transmission
Data
According to the Context in
Parameters of an MG Interface
confirmed with the engineers of the
office, the default configuration can
meet the service requirements.
Therefore, the software parameters are
not configured.
Confirmed with the engineers of the
office, the value of the ringing
parameter (corresponding to the users)
specified on the MGC is 0 (value of
mgcpara), and the users have no special
requirements for the ringing mode.
Therefore, the normal ringing with the
break-make ratio of 1:4 is adopted.
To differentiate users by terminal ID
(TID), the engineers of the office
require that the terminal prefix uses the
community name huawei and the TID
is automatically generated by the
system according to the slot ID/shelf
ID/port ID of the user.
Run the display tid-template
command to query the default TID
template. It is found that default TID
template (template 6) can meet the
requirements.
The user is accessed through the 0/3
port on the ASRB board.
The emergency standalone is not
supported. Therefore, you need not
configure the phone number when
adding a user.
Phone numbers allocated by the MGC
for phone 0-phone 31 are
83110000-83110031.
NOTE
Generally, No telephone number (namely,
parameter telno) is configured on the MG,
because telephone numbers are specified by
the MGC.
The terminal layering is supported.
Therefore, the TID need not be
allocated manually.
Software
and
437