Huawei SmartAX MA5616 Configuration Manual page 61

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Procedure
Step 1 Run the ancp session command to enter the ANCP session mode.
Step 2 Run the ancp ip command to configure the GSMP communication IP address for the ANCP
session.
l The IP address configured here must be the same as the GSMP communication IP address
l When an ANCP session is enabled, the GSMP communication IP address cannot be
Step 3 (Optional) Run the ancp capability command to configure the capability set of the ANCP
session. The default value is all, that is, the three capabilities (topology discovery, line
configuration, and L2C OAM) are supported.
l Supports topology discovery. When you select topology-discovery parameter, the DSLAM
l Supports line configuration. When you select line-config parameter, the DSLAM responds
l Supports the OAM. When you select oam parameter, the DSLAM responds to the line testing
l Supports the preceding three types of capabilities, when you select all.
Step 4 (Optional) Run the ancp ancp-8021p command to set the priority for sending ANCP packets.
You can set the priority according to the actual requirements and network conditions, the higher
the priority, the higher the reliability.
Step 5 (Optional) Run the ancp nas-tcp-port command to set the GSMP TCP communication port ID
for the ANCP session on the NAS. By default, the GSMP TCP communication port ID is 6068.
The GSMP TCP communication port ID on the MA5616 must be the same as that on the NAS.
Step 6 (Optional) Run the ancp init-interval command to set the interval for sending packets during
the establishment of the ANCP session. By default, the general query interval is 1s.
Step 7 (Optional) Run the ancp keep-alive command to set the interval for sending packets during the
ACNP session so that the handshake messages can be sent to the peer end at the preset interval.
By default, the interval is 25s.
Step 8 Run the ancp enable command to enable the ANCP function. By default, the ANCP function
is disabled.
Issue 04 (2011-10-30)
NOTE
Currently, the system supports only two ANCP sessions.
configured on the NAS, but it should to not be the same as the default IP address, multicast
IP address, or broadcast IP address.
configured.
automatically reports the line parameters to the NAS.
to the line configuration that is sent by the NAS.
information that is sent by the NAS.
NOTE
After an ANCP session is enabled, the priority for sending the ANCP packet of the ANCP session cannot
be configured.
NOTE
After an ANCP session is enabled, the priority for sending the ANCP packet of the ANCP session cannot
be configured.
NOTE
After an ANCP session is enabled, the priority for sending the ANCP packet of the ANCP session cannot
be configured.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Basic Configuration
50