Huawei SmartAX MA5616 Configuration Manual page 231

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Table 7-4 Software parameters of an MG interface that supports H.248
Parameter
2
Issue 04 (2011-10-30)
Description
Indicates whether the MG
interface supports dual homing.
To configure an MG interface
to or not to support dual
homing, use this parameter.
This parameter can be
configured only when the MG
interface is in the local closed
state.
If the MG interface does not
support dual homing, even if the
secondary MGC is configured,
the MG interface does not
switch to registering with the
secondary MGC when the MG
interface fails to register with
the primary MGC. If the MG
interface supports dual homing
and auto-switching, even if the
MG interface has registered
with the secondary MGC, the
MG interface can automatically
switch back to the primary
MGC if the primary MGC
recovers. If the MG interface
supports dual homing, you can
run the mgc_switch(h248)
command to perform the MGC
switching.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Default Setting
Numeral type. Range: 0-2.
l 0: Indicates that dual homing
is not supported.
l 1: Indicates that dual homing
rather than auto-switching is
supported.
l 2: Indicates that dual homing
and auto-switching is
supported.
Default: 0
220