Huawei SmartAX MA5616 Configuration Manual page 38

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Figure 3-18 Flowchart for configuring inband management in the telnet mode
Procedure
Step 1 Set up the configuration environment.
Figure 3-16
the actual requirements and conditions.
Step 2 (Optional) Configuring the attributes of the uplink port.
Generally, the uplink port on the 0/0/0 does not need to be set in optical-electrical mode. If the
uplink link fails, perform the following steps:
1.
2.
3.
For details about how to set the uplink port attributes, see
Port.
Step 3 Configure the IP address of the VLAN L3 interface.
Issue 04 (2011-10-30)
Start
Set up the configuration
environment
Configure the IP address
of the VLAN L3 interface
Is it a WAN
environment?
Yes
Add a route
Start Telnet on the
maintenance terminal
Log in to the system
End
or Figure 3-17
Run the combo-mode command to switch the Ethernet port mode.
Run the auto-neg 0 disable command to disable the autonegotiation mode of the port.
Run the speed command to set the rate of the Ethernet port at the local end so that it is the
same as that at the peer end.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
No
shows how to set up the configuration environment according to
3 Basic Configuration
3.3.1 Configuring an Uplink Ethernet
27