Huawei SmartAX MA5616 Configuration Manual page 530

SmartAX MA5616 Multi-service Access Module
Configuration Guide
----End
Result
After the configuration is completed, users can make calls between two phones.
l
Issue 04 (2011-10-30)
port
2944 mg-media-ip1 17.10.10.10
7. Reset the MG interface.
NOTE
l You must reset the MG interface after configuring and set the type to cold reset. Otherwise the
MG interface is invalid.
l Only the mgip, mgport, mgcip_1 (or mgc-domain-name1), mgcport_1, code, transfer, mg-
media-ip parameters are set correctly, you can cold reset the MG interface.
huawei(config-if-h248-0)#reset coldstart
Are you sure to reset MG interface?(y/n)[n]:y
huawei(config-if-h248-0)#quit
8. Configure the PSTN user data.
Configure the telephone number of the user on port 0/2/0 to 0/2/23, telephone number
of the user from 83110001 to 83110024, and terminal ID to 0.
NOTE
l This telephone number is used to self-exchange, means the communication of extension. The
real telephone numbers are ranged by MGC.
l The ONU configured with an ASRB board has 32 POTS ports and an MA5616 configured with
an ASPB board has 64 POTS ports. Configuring 24 PSTN users is used as an example.
l To configure the PSTN data of a single user, run the mgpstnuser add command.
l To configure the PSTN data of multiple users in batches, run the mgpstnuser batadd command.
l If the user of the MG interface is configured to support terminal layering, you need not configure
the terminal ID and the system automatically allocates it. If the user of the MG interface does
not support terminal layering, this parameter is mandatory. The terminal ID must be unique on
one MG interface.
huawei(config)#esl user
huawei(config-esl-user)#mgpstnuser batadd 0/2/0 0/2/23 0 terminalid 0
telno 83110001
9. Change the call priority of the PSTN user.
Configure the call priority of the user on port 0/2/0 to Cat2 and the users of 0/2/1 to
0/2/23 to Cat3 (Default)
huawei(config-esl-user)#mgpstnuser modify 0/2/0 priority cat2
huawei(config-esl-user)#quit
10. Modify the attributes of all the PSTN ports so that the PSTN ports support the polarity
reversal.
Modify the attributes of the PSTN port 0/2/0 to 0/2/23 so that the PSTN ports support
the polarity reversal.
huawei(config)#pstnport
huawei(config-pstnport)#pstnport attribute batset 0/2/0 0/2/23 reverse-
pole-pulse enable
huawei(config-pstnport)#quit
11. Save the data.
huawei(config)#save
The caller can hear the dial tone after picking up the phone.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Configuration Examples of the FTTx
519