Table of Contents
Advertisement
SmartAX MA5616 Multi-service Access Module
Configuration Guide
Procedure
Step 1 In global config mode, run the interface h248 command to enter the MG interface mode.
Step 2 Run the mg-software parameter 4 command to configure the registration mode.
Step 3 Run the mg-software parameter 6 0 command to configure the MG interface to support the
device authentication.
Step 4 Run the auth command to configure the authentication MG ID and the initial key.
Step 5 Run the display auth command to query the device authentication parameters.
Step 6 Run the reset coldstart command to reset the MG interface.
----End
Example
To configure the device authentication parameters shown in the
do as follows:
Table 7-31 Data plan for configuring the authentication parameters (H.248)
Configuration Item
MGID
Whether to use the wildcard in registration
Whether to support the device
authentication.
Authentication MG ID
Initial key
huawei(config)#interface h248 0
huawei(config-if-h248-0)#mg-software parameter 4 0
huawei(config-if-h248-0)#display mg-software parameter 4
-------------------------------------------------
Interface Id:0
-------------------------------------------------
APPENDIX:
-------------------------------------------------
huawei(config-if-h248-0)#mg-software parameter 6 0
huawei(config-if-h248-0)#display mg-software parameter 6
-------------------------------------------------
Interface Id:0
Issue 04 (2011-10-30)
Interface software parameter name:
4: Whether MG uses wildcard in registration
0: Yes
1: No
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value
0
Yes
Yes
MA5616
It must be the same as the configuration on the
MGC. Otherwise, the MG cannot register with
the MGC.
Default: 0123456789ABCDEF.
It must be the same as the initial key configured
on the MGC.
para index:4
value:0
para index:6
value:0
7 Configuring the Voice Service
Table 7-31
for the MA5616,
307
Hide quick links:
Advertisement
Table of Contents
