Huawei SmartAX MA5616 Configuration Manual page 26

SmartAX MA5616 Multi-service Access Module
Configuration Guide
l Baud rate: 9600 bit/s
l Data bit: 8
l Parity: None
l Stop bit: 1
l Flow control: None
Figure 3-5 Setting the parameters of the HyperTerminal
Click OK, and the HyperTerminal interface is displayed, as shown in
Issue 04 (2011-10-30)
NOTE
l The baud rate of the HyperTerminal must be the same as that of the serial port on the MA5616. By
default, the baud rate of the serial port on the MA5616 is 9600 bit/s.
l There may be illegible characters in the displayed input information after you log in to the system. This
is because the baud rates between the HyperTerminal and the MA5616 are not the same. In this case,
set a different baud rate to log in to the system. The system supports the baud rates of 9600 bit/s, 19200
bit/s, 38400 bit/s, 57600 bit/s, and 115200 bit/s.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Basic Configuration
Figure 3-6.
15